Contact Us
TEL:+86-510-85918899
Fax: +86-510-85917799
E-mail: 13806188022@163.com
Address: No.18 Longdan road, Hu Dai Industrial Park, Binhu district, Wuxi, Jiangsu province, China
Home > Knowledge > Content
Keep in mind when using and maintaining stainless steel reactors
Sep 17, 2018

When using the stainless steel reactor, remember to close the refrigerant inlet valve, drain the remaining refrigerant in the pot and the jacket, input the material, start the stirrer; then turn on the steam valve and the electric heating power to reach the required temperature. The steam valve and the electric heating source should be turned off first, and after 2 to 3 minutes, the agitator is turned off.

 

After the processing in the stainless steel reactor is finished, after draining the remaining condensed water in the pot and the jacket, it should be rinsed with warm water as soon as possible; then it should be thoroughly cleaned on the inner wall of the vessel with 40 °C ~ 50 °C alkaline water, and rinsed with water, especially stainless steel reactor When there is no material empty pot in the pot, the steam valve and the electric heating power source shall not be turned on. Pay special attention to the use of steam pressure and shall not exceed the rated working pressure.

 

In the maintenance of the stainless steel reaction kettle, it is necessary to pay attention to the operation of the whole equipment and reducer, the reducer lubricant should be replenished in time, the electric heating medium oil should be replaced every six months, on the jacket and the lid. Safety valves, pressure gauges, distillation holes, electric heating rods, electrical instruments, etc. should be inspected regularly. When the equipment is not in use, it must be thoroughly cleaned with warm water on the inner and outer walls of the container. The pot body is often scrubbed to keep the outer surface clean and the inner tube bright, achieving the purpose of durability.http://www.wxlsshzb.com/


Previous: Stirring method and performance requirements of resin reactor

Next: Sealing method of chemical reactor seal