Contact Us
TEL:+86-510-85918899
Fax: +86-510-85917799
E-mail: 13806188022@163.com
Address: No.18 Longdan road, Hu Dai Industrial Park, Binhu district, Wuxi, Jiangsu province, China
Home > Knowledge > Content
Correct design of temperature in stainless steel reactor
Nov 03, 2018

The pressure value set by the stainless steel reactor during operation is subject to certain regulations. We must handle it according to the provisions of GB 150. Since the surface of the stainless steel reactor is made of metal, the products we need to process are also made of metal, so we must maintain temperature stability.

 

The temperature of the stainless steel reactor should also be paid attention to. The temperature mentioned here refers to the temperature of the metal. It mainly refers to the temperature measurement of the cross section of the component after the pressure of the container. The measured temperature is the metal temperature. In any case, the surface temperature of the component metal must not exceed the allowable temperature of the steel.

 

Another is the design temperature of the stainless steel reactor, which is the highest or lowest temperature that the vessel wall or component metal may reach under normal design conditions under the appropriate design pressure. When the temperature of the shell wall or component metal is lower than -20 ° C, the design temperature is determined at the lowest temperature. In addition, the design temperature is selected according to the highest temperature; the design temperature value shall not be lower than the highest metal temperature that the component metal may reach; for metal temperatures below 0 °C, the design temperature shall not be higher than the lowest metal temperature that the component metal may reach. .http://www.wxlsshzb.com/


Previous: Points to note when operating the mixing kettle

Next: What are the reaction vessels and what are the specific types?