Fax: +86-510-85917799
E-mail: submit@wxlsshzb.com
Address: No.18 Longdan road, Hu Dai Industrial Park, Binhu district, Wuxi, Jiangsu province, China





Gasket Plate Heat Exchanger Introduction The shim plate heat exchanger is composed of a set of corrugated metal plates with holes on the plate for the passage of two liquids for heat transfer. The metal sheet is mounted in a frame having a fixed plate and a movable pressing plate on one side and...
Gasket Plate Heat Exchanger Introduction
The shim plate heat exchanger is composed of a set of corrugated metal plates with holes on the plate for the passage of two liquids for heat transfer. The metal sheet is mounted in a frame having a fixed plate and a movable pressing plate on one side and clamped by a clamp bolt. A gasket is placed over the plate to seal the fluid passages and direct fluid flow alternately into the respective passages. The flow rate, physical properties, pressure drop and temperature difference of the liquid determine the number of plates. The chemical properties and corrosion characteristics of the liquid determine the material of the plates and pads. The unfair design of different corrugated plates improves the degree of turbulence, and A number of support points are formed to withstand the pressure difference between the media.
Feature:
The metal plate and the movable compression plate are mounted on the suspension beam and are positioned by the lower guide bar, and the rod end is fixed on the support column, but if one of the liquid or two liquids passes through the heat exchanger more than once, then The interface should be open on the plate and the movable platen.
The reasonable matching of the corrugation angle of the plate can greatly improve the heat exchange effect of the unit heat exchange area, adjust the resistance of the liquid, and save the heat exchange area, thereby reducing the investment cost and shortening the investment recovery time.
Sheet material:
Stainless steel: SUS304, 316, 316L, 310S, 904
Titanium and Titanium Palladium Alloys: TAi, TAi-Pd
Hastelloy: C276, D205, B2G
Nickel: Ni200
Molybdenum: 254MO
Product parameters:
Pressure range: no more than 2.5MPa
Maximum processing capacity: 1500m3/h
Minimum throughput: 1m3/h
Assembly area: 800m2
Temperature range: -50 - 350 ° C
Maximum interface: DN350
Minimum interface: DN32
Heat load: 10MW
Plate thickness: 0.5 - 0.8mm
Workshop: