Contact Us
TEL:+86-510-85918899
Fax: +86-510-85917799
E-mail: 13806188022@163.com
Address: No.18 Longdan road, Hu Dai Industrial Park, Binhu district, Wuxi, Jiangsu province, China
Working Principle Of Reactor

Working Principle Of Reactor

Working principle of reactor Introduction The reaction vessel is a comprehensive reaction vessel, and the structure of the reactor structure and the configuration of the accessories are designed according to the reaction conditions. From the beginning of the feed-reaction-discharge, the pre-set...

Working principle of reactor Introduction

The reaction vessel is a comprehensive reaction vessel, and the structure of the reactor structure and the configuration of the accessories are designed according to the reaction conditions. From the beginning of the feed-reaction-discharge, the pre-set reaction steps can be completed with a high degree of automation, temperature, pressure, mechanical control (stirring, blasting, etc.), reactants/products during the reaction. Strict regulation of important parameters such as concentration.


Feature:

The reaction solvent can be placed in the inner layer to perform a stirring reaction, and the interlayer can be heated or cooled by a different cold and heat source (refrigerant, hot water or hot oil). The constant temperature (high temperature or low temperature) hot-dissolving medium or cooling medium is injected through the reaction vessel interlayer, and the materials in the reaction kettle are heated or cooled at a constant temperature. At the same time, the stirring reaction can be carried out under normal pressure or under negative pressure according to the use requirements. The material is reacted in the reaction vessel, and the evaporation and reflux of the reaction solution can be controlled. After the reaction is completed, the material can be discharged from the discharge port of the bottom of the kettle.


Workshop:

1.jpg


Maintenance of the reaction kettle should always pay attention to the operation of the whole equipment and reducer. If the reducer oil is insufficient, it should be replenished immediately. The electric heating medium oil should be replaced every six months. The safety valve and pressure gauge on the jacket and the upper part of the cover, Temperature gauges, distillation holes, electric heating rods, electrical instruments, etc. should be inspected regularly. If there is any fault, it should be replaced or repaired immediately. When the equipment is not in use, it must be thoroughly cleaned with warm water in the inner and outer walls of the container. The pot body is often scrubbed to keep the appearance clean and inside. Bright and daring for durability.


Hot Tags: working principle of reactor, China, manufacturers, suppliers, factory, price, custom
Inquiry