Contact Us
TEL:+86-510-85918899
Fax: +86-510-85917799
E-mail: 13806188022@163.com
Address: No.18 Longdan road, Hu Dai Industrial Park, Binhu district, Wuxi, Jiangsu province, China
Home > Knowledge > Content
High pressure reactor structure and precautions and how to clean
Jun 27, 2018

The reactors can be said to be of various types. Therefore, if you want to have a complete understanding of the reactor, you cannot omit any of its specific categories. Otherwise, you cannot achieve the goal. Therefore, the next step is to introduce the description of the reactor, which is a high-pressure reactor, so that it can be known as what kind of reactor and how to use it.

 

1. What is a high pressure reactor?

The high-pressure reaction vessel, which is a type of reaction vessel, is a specific type obtained by applying a magnetic force transmission device to a reaction device, and can fundamentally solve the problem of shaft seal leakage that cannot be overcome by the packing seal and the mechanical seal. No leakage and no pollution. In addition, it is also possible to carry out chemical reactions under conditions of high temperature and high pressure, especially chemical reactions of flammable, explosive or toxic media, to ensure the safety of the reaction and avoid danger.

 

2. Structure of high pressure reaction

In the high-pressure reactor, the material of the kettle body is 1cr18Ni10Ti stainless steel, or according to different requirements, titanium materials, nickel and composite steel plates may be used. In the kettle structure, there are flat lids, convex lids, and closed reactor bodies with manholes. If necessary, open the hole in the lid of the kettle. In the heating mode, jacketed steam heating, jacketed hot oil electric heating, etc. are available.

 

In addition, mirror polish can be performed on this kind of reactor if it is required for polishing. If it is a high-viscosity medium, the reactor can be made into a conical bottom to facilitate discharge and cleaning.

 

3 high pressure reactor cleaning

First, the reactor solvent was charged into the kettle from the exhaust valve to wash away the residue from the kettle. Then, the water was stirred for 10 minutes and then the lid was opened and the inner wall was cleaned. In this process, it should be noted that the kettle cover and sampling valve of the reactor must be cleaned. At the same time, if there is water in the reactor, nitrogen can be charged to help with the cleaning work. In addition, if you do not use a reactor for the time being, you should inject 70% of clean absolute ethanol into the reactor. You can not tighten the screws at this time.

 

4. The use of high pressure reactor Note

High-pressure reactor This type of reactor should be used at the designated place and used according to the specification. Before use, be sure to know the product's test pressure, pressure and conditions of use, and use within its allowable range. The pressure gauge it uses should always be compared to a standard pressure gauge in order to correct and maintain the accuracy of the gauge.http://www.wxlsshzb.com/


Previous: Material for spiral plate in spiral plate heat exchanger

Next: What is a stainless steel tank and how is it maintained?